30
Setting up the 810
System
Stage 2: Projector settings
The Configuration Wizard provides access to the
essential projector settings, needed to obtain a visible
on-screen display.
Once these settings have been configured correctly,
further settings can be adjusted using the remote
control and on-screen display, as described in
Adjusting
the projector, page 36.
To configure the projector settings
Either:
Press Skip after resetting the product; see
Stage 1:
Resetting the product
, page 29.
Or:
Press Wizard; see
Configuration Wizard
, page 28.
Press Skip to skip past the Reset settings menu.
The display shows the title screen for stage 2:
%NTER 3KIP"ACK
0ROJSETTINGS
Press Enter to proceed or Skip to go to stage 3.
The display shows the first projector setting, Test
Pattern, and the current value of that setting, Off:
z{|wxy"ACK .EXT
4EST0ATTERN
3ET
/FF
Press Next or Back to step between settings.
The options are summarised in the table on the next
page.
To change a setting
Press A or V to step through the alternative values
for the setting.
•
•
•
•
•
•
To move to the next setting
Press Source.
When you have finished configuring projector settings:
Either:
Press Next on the last option of the last source
(Force Signal) to proceed to configuring settings, as
described in the next section.
Or:
Press Power to return to standby.
•
•
•
Kommentare zu diesen Handbüchern