Meridian G02 Installationsanleitung PDF herunterladen (Seite 21)

C o n f i g u r i n g t h e

c o n t r o l u n i t o r

r e c e i v e r

1 7

Configuring the control unit or receiver

This chapter explains how to configure the control unit or receiver using the Configuration

Wizard.

Alternatively, for complete control over all aspects of the product’s configuration you can set

up the unit from a computer using the Meridian Configuration Program. For full information

refer to the

Meridian Configuration Program Guide

available separately.

Configuration Wizard

The Configuration Wizard leads you through the correct

sequence to configure your control unit or receiver. Alternatively,

you can skip between the configuration stages, which allow you to

reset the configuration, or configure the sources or other settings

of the control unit or receiver.

To run the Configuration Wizard

• If necessary press On/Off to put the control unit or receiver into

standby.

• Press More.

If the product is locked the display shows:

UnlockVersion

• Press Unlock to unlock it, then press More.

The displays then shows:

Wizard

LockVersion

• Press Wizard.

Follow the sequence of configuration stages described in the

following pages, pressing Next to proceed after completing each

stage.

To go back to an earlier configuration option

• Press Back.

To return to the title screen for each stage

• Press Home.

To exit from the Configuration menus

• Press On/Off.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Keine Kommentare

Meridian G02 Installationsanleitung Seite 21